Chapter 9
About the Interface
Using the Command Line Interface
This section explains how to use the command line interface (CLI) to administer
the PX3TS.
Note that available CLI commands are model dependent.
CLI commands are case sensitive.
In This Chapter
About the Interface .......................................................................................... 524
Logging in to CLI ................................................................................................ 525
Showing Information ........................................................................................ 530
Clearing Information ......................................................................................... 562
Unblocking a User ............................................................................................. 703
Resetting the PX3TS .......................................................................................... 704
Logging out of CLI ............................................................................................. 710
The PX3TS provides a command line interface that enables data center
administrators to perform some basic management tasks.
Using this interface, you can do the following:
•
Reset the PX3TS
•
Display the PX3TS and network information, such as the device name,
firmware version, IP address, and so on
•
Configure the PX3TS and network settings
•
Troubleshoot network problems
You can access the interface over a local connection using a terminal emulation
program such as HyperTerminal, or via a Telnet or SSH client such as PuTTY.
Note: Telnet access is disabled by default because it communicates openly and
is thus insecure. To enable Telnet, see
Changing Telnet Settings
(on page 344).
524