Table of Contents
Advertisement
Chapter 6: Using the PX3TS
154
To switch on or off an actuator:
1.
Follow the above steps 1 to 3 to select an actuator.
2.
Press
to turn on or off the actuator. A confirmation message similar
to the following is shown.
3.
Press
or
4.
Verify that the actuator status shown on the LCD display has been
changed.
Assets
If there are no Raritan asset management strips connected, the LCD display
shows the message "No asset strips connected" for the "Assets" menu
command.
After connecting asset strips, only the information of the rack units where asset
tags have been detected is shown on the LCD display.
To show asset strip information:
1.
Press
or
2.
The display shows the available asset strip, and indicates how many rack
units and tags are detected on this strip.
to select Yes or No, and then press
to select "Assets" in the Main Menu, and press
.
.
Advertisement
Table of Contents
Troubleshooting
