Front Panel Settings - LEGRAND Raritan PX3TS User Manual

Chapter 7: Using the Web Interface
454
Note: If you have not configured the System SNMP Notification Action to specify
the SNMP destination(s), see

Front Panel Settings

You can set up the default mode of the front panel display, and front panel
functions for actuator control, beeper mute or RCM self-test.
Note that available front panel settings are model dependent.
•
Actuator control -- available on all models.
•
Internal beeper's mute function -- available on all PX3TS models.
•
Default front panel mode setup -- available on all models.
•
RCM self-test -- available on those PX3TS models which support residual
current monitoring. See PX3TS Models with Residual Current Monitoring.
To configure the front panel settings:
1. Choose Device Settings > Front Panel.
2. Configure the following:
▪
To configure the default view of the LCD display, select one mode
below.
Note: The default view is shown in the automatic mode. See
Manual Modes (on page 140).
Mode
Automatic mode
Inlet overview
▪
To enable the front panel actuator-control function, select the
'Peripheral actuator control' checkbox.
▪
The built-in beeper's mute control function is enabled per default. To
disable it, deselect the 'Mute beeper' checkbox.
▪
By default the front panel RCM self-test function, if available, is
enabled. See Disabling or Enabling Front Panel RCM Self-Test.
3. Click Save.
If the 'Mute beeper' feature is enabled, you can operate the front panel to
mute it whenever it beeps. See Muting the Internal Beeper.
Editing or Deleting a Rule/Action
Data entered
The LCD display cycles through both the
transfer switch/inlet and overcurrent
protector information. This is the default.
Overcurrent protector information is available
only when your PX3TS has overcurrent
protectors.
The LCD display cycles through the transfer
switch/inlet information only.
(on page 429).
Automatic and