LEGRAND Raritan PX3TS User Manual page 171

▪
Cycle: Power cycle the outlet. The outlet is turned off and then on.
7. A confirmation message appears. Press
and then press
▪
Yes: Confirm the operation.
▪
No: Abort the operation.
8. Verify that the selected outlet is switched on or off, depending on the
option you selected in the above step.
▪
Check the outlet state shown on the LCD display -- red or green circles.
▪
Check the outlet LED. A green LED indicates that the outlet is turned
off, and a red LED indicates that the outlet is turned on.
9. To return to the Main Menu, press
Menu is shown.
Peripherals
If there are no Raritan environmental sensor packages connected to your
PX3TS, the LCD display shows the message "No managed devices" for the
"Peripherals" menu command.
If you have enabled the front panel actuator control function, you can switch
on or off a connected actuator using the LCD display. See
page 462).
To show environmental sensor or actuator information:
1. Press or
.
2. The display shows a list of environmental sensors/actuators.
▪
If the desired sensor or actuator is not visible, press
scroll up or down.
▪
When the list exceeds one page, the currently-selected
sensor/actuator's ID number and total of managed sensors/actuators
are indicated in the top-right corner of the display.
▪
If any sensor enters the warning, critical, or alarmed state, like 'Tamper
Detector 1' shown below, it is highlighted in yellow or red. For color
definitions, see
.
several times until the Main
to select "Peripherals" in the Main Menu, and press
Yellow- or Red-Highlighted Sensors
Chapter 6: Using the PX3TS
or to select Yes or No,
Miscellaneous (on
or
(on page 264).
to
151