Rebooting The Px3Ts; Resetting All Settings To Factory Defaults - LEGRAND Raritan PX3TS User Manual

Rebooting the PX3TS

You can remotely reboot the PX3TS via the web interface.
Resetting the PX3TS does not interrupt the operation of connected servers
because there is no loss of power to outlets. During and after the reboot,
outlets that have been powered on prior to the reboot remain powered on,
and outlets that have been powered off remain powered off.
Warning: Rebooting the PX3TS deletes all webcam snapshots that are saved
onto the PX3TS locally. If needed, download important snapshots before
rebooting the device. See
(on page 500).
To reboot the device:
1. Choose Maintenance > Unit Reset >
2. Click Reboot to restart the PX3TS.
3. A message appears, with a countdown timer showing the remaining time
of the operation. It takes about one minute to complete.
4. When the restart is complete, the login page opens.
Tip: If you are not redirected to the login page after the restart is complete, click
the text "this link" in the countdown message.
Note: Device reset will cause CLI communications over an "USB" connection to
be lost. Therefore, re-connect the USB cable after the reset is complete.

Resetting All Settings to Factory Defaults

You must have the Administrator Privileges to reset all settings of the PX3TS to
factory defaults.
Important: Exercise caution before resetting the PX3TS to its factory defaults.
This erases existing information and customized settings, such as user profiles,
threshold values, and so on. Only active energy data and firmware upgrade
history are retained.
Chapter 7: Using the Web Interface
Viewing and Managing Locally-Saved Snapshots
.
491