Supported Sensor Configurations For Power Sharing - LEGRAND Raritan PX3TS User Manual

Supported Sensor Configurations for Power Sharing

All information and restrictions described in this section apply to BOTH PDUs
involved in the power-sharing configuration, unless otherwise specified.
•
There are no limitations for connecting Raritan's DPX or DPX2
environmental sensor packages to an iX7
See DPX Sensor Packages
48).
•
The maximum number of supported DPX3 environmental sensor packages
remains unchanged -- that is, 12 DPX3 packages. See
Packages (on page 46).
•
The maximum number of supported DX environmental sensor packages
also remains unchanged as long as the DPX3-ENVHUB4 sensor hub is not
used -- that is, 12 DX sensor packages. See
45).
•
The maximum number of supported DX2 environmental sensor packages
remains unchanged -- that is, 12 DX2 packages. See
(on page 43).
However, there are DX restrictions when DPX3-ENVHUB4 is used, and there are
also door handles-related restrictions.
DX sensor restrictions while DPX3-ENVHUB4 is involved:
•
A maximum of one DPX3-ENVHUB4 and a maximum of 10 DX sensor
packages are supported.
Door handle connection restrictions (via DX2-DH2C2 or DX-PD2C5):
•
(Restriction only for DX2-DH2C2 manufactured before 2019) DO NOT
connect any "SouthCo H3-EM series" door handle(s) because of insufficient
power supply in the power-sharing mode.
Note: The latest generation of DX2-DH2C2 does NOT have this restriction
and can have SouthCo H3-EM series connected in the power-sharing mode.
•
A maximum of 2 door handles connected to a maximum of one
DX2-DH2C2 or one DX-PD2C5 package are supported.
•
All of the 2 door handles must be controlled by the same PDU so that you
can have "only one" handle opened at a time to avoid critical power
consumption. That is, ALL door handles must be connected to only one
PDU in the power-sharing connection, NOT both PDUs.
Note: It is strongly suggested to check and make sure the upper limit of
"powered cry contact actuators" is set to 1 when making a power-sharing
connection. See Peripherals
Chapter 3: Initial Installation and Configuration
PDU in the power-sharing mode.
™
(on page 51) or DPX2 Sensor Packages
DX Sensor Packages
(on page 258).
(on page
DPX3 Sensor
(on page
DX2 Sensor Packages
39