Chapter 9: Using the Command Line Interface
550
Authentication Settings
General authentication settings:
This command displays the authentication settings of the PX3TS, including both
LDAP and Radius settings.
#
show authentication
One LDAP server's settings:
To show the configuration of a specific LDAP server, assign the desired LDAP
server with its sequential number in the command. To get detailed information,
add "details" to the end of the command.
#
show authentication ldapServer <server_num>
-- OR --
#
show authentication ldapServer <server_num>
One Radius server's settings:
To show the configuration of a specific Radius server, assign the desired Radius
server with its sequential number in the command. To get detailed information,
add "details" to the end of the command.
#
show authentication radiusServer <server_num>
-- OR--
#
show authentication radiusServer <server_num> details
Variables:
•
<server_num> is the sequential number of the specified authentication
server on the LDAP or Radius server list.
Displayed information:
•
Without specifying any server, PX3TS shows the authentication type and a
list of both LDAP and Radius servers that have been configured.
•
When specifying a server, only that server's basic configuration is displayed,
such as IP address and port number.
•
With the parameter "details" added, detailed information of the specified
server is displayed, such as an LDAP server's bind DN and the login name
attribute, or a Radius server's timeout and retries values.