LEGRAND Raritan PX3TS User Manual page 551

- Surge protector state*
•
Automatic retransfer enabled or disabled*
- Phase sync required or not*
- Wait time for automatic retransfer*
•
Front panel Manual Transfer button enabled or disabled*
The above information marked with * is retrievable with the "show ts details"
command only.
Power Quality Settings
This command shows the power quality criteria of the PX3TS device, including
voltage and frequency thresholds per inlet.
# show ts powerQualityParameters
Transfer Timing Statistics
This command shows statistics on how long a power transfer takes, including
power failure detection time, relay open time and total transfer time (in
milliseconds).
# show ts transferTimingStatistics
Inlet Phase Sync Angle Information
This command syntax shows the inlet phase sync angle sensor's information.
# show sensor ts inletPhaseSyncAngle
To show detailed information, add the parameter "details" to the end of the
command.
# show sensor ts inletPhaseSyncAngle details
Displayed information:
•
Without the parameter "details," only the reading, state, threshold,
deassertion hysteresis and assertion timeout settings of the inlet phase
sync angle are displayed.
•
With the parameter "details," more sensor information is displayed,
including resolution and range.
Chapter 9: Using the Command Line Interface
531