Asset Management Commands - LEGRAND Raritan PX3TS User Manual

Chapter 9: Using the Command Line Interface
686
Setting the Polling Interval
This command syntax determines the polling interval at which the Cisco
EnergyWise domain queries the PX3TS.
config:# energywise polling <timing>
Variables:
•
<timing> is an integer number in seconds. It ranges between 30 and 600
seconds.
Example - Setting Up EnergyWise
The following command sets up two Cisco
config:# energywise enabled true port 10288
Results:
•
The EnergyWise feature implemented on the PX3TS is enabled.
•
The UDP port is set to 10288.

Asset Management Commands

You can use the CLI commands to change the settings of the connected asset
strip (if any) or the settings of LEDs on the asset strip.
Asset Strip Management
An asset strip management configuration command begins with
assetStrip.
EnergyWise-related features.
®
®