System And Usb Requirements - LEGRAND Raritan PX3TS User Manual

Appendix C: Configuration or Firmware Upgrade with a USB Drive

System and USB Requirements

732
▪
If no firmware upgrade task will be performed, a happy smiley is
displayed after around 30 seconds.
The happy smiley looks like one of the following, depending on your
Raritan product. For the first diagram, its background color will turn
green.
▪
If the USB drive contains the firmware upgrade data, the PX3TS:
a. First performs the firmware upgrade, showing the upgrade message
on the front panel display.
b. Then shows the happy smiley when the firmware upgrade completes
successfully. See
6. After the happy smiley appears, press one of the control buttons next to
the display for one second until the smiley disappears.
Tip: You can remove the USB drive and plug it into another PX3TS device for
performing the same task(s) once the happy smiley or the firmware
upgrade message displays.
7. Wait for several seconds until the PX3TS resumes normal operation,
indicated by the normal message of the display.
If nothing is shown on the display and no task is performed after plugging the
USB drive, check the log file in the USB drive.
You must satisfy ALL of the following requirements prior to using a USB flash
drive to perform device configuration and/or firmware upgrade.
PX3TS system requirements:
•
There is at least one USB-A port available on your Raritan device.
•
Your PX3TS must run firmware version 2.2.13 or later.
Note that the PX3TS interpreted the USB drive's contents using the
firmware which was running when plugging the USB drive, not the new
firmware after firmware upgrade.
USB drive requirements:
•
The drive contains either a single partition formatted as a Windows FAT32
filesystem, or NO partition tables (that is, a superfloppy-formatted drive).
•
The drive contains a configuration file called fwupdate.cfg in its root
directory. See fwupdate.cfg
Firmware Upgrade via USB
(on page 734).
(on page 744).