Reserving Ip In Windows - LEGRAND Raritan PX3TS User Manual

Interface Client identifier
ETH2 serial number plus the uppercase suffix "-ETH2"
WIRELESS serial number plus the uppercase suffix "-WIRELESS"
BRIDGE serial number
You can reserve the IP addresses of more than one interfaces in the DHCP
server if preferred. Note that you must choose/configure the bridge interface if
your PX3TS is set to the bridging mode.
Important: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces
do NOT function.

Reserving IP in Windows

To reserve the IP address of any network interface in the Windows DHCP server,
you must convert that interface's client identifier into hexadecimal ASCII codes.
For each interface's client identifier, see
Servers (on page 830).
In the following illustration, it is assumed that the PX3TS serial number is
PEG1A00003.
Windows IP address reservation illustration:
1. Convert the client identifier of the desired network interface into ASCII
codes (hexadecimal).
Interface
ETH1
ETH2
WIRELESS
BRIDGE
2. In your DHCP server, bring up the New Reservation dialog, and separate
the converted ASCII codes with spaces.
For example, to reserve the ETH1 interface's IP address, enter the following
data in the dialog.
Appendix J: Additional PX3TS Information
Reserving IP Addresses in DHCP
Client identifier conversion
PEG1A00003 = 50 45 47 31 41 30 30 30 30 33
PEG1A00003-ETH2 = 50 45 47 31 41 30 30 30 30 33 2D 45
54 48 32
▪ The suffix comprising the dash symbol and the word
"ETH2" is also converted.
PEG1A00003-WIRELESS = 50 45 47 31 41 30 30 30 30 33 2D
57 49 52 45 4C 45 53 53
▪ The suffix comprising the dash symbol and the word
"WIRELESS" is also converted.
PEG1A00003 = 50 45 47 31 41 30 30 30 30 33
831