LEGRAND Raritan PX3TS User Manual page 636

Chapter 9: Using the Command Line Interface
616
Specifying the Agreement Contents
This command allows you to create or modify contents of the Restricted
Service Agreement.
config:# security restrictedServiceAgreement bannerContent
After performing the above command, do the following:
1. Type the text comprising up to 10,000 ASCII characters when the CLI
prompts you to enter the content.
2. To end the content:
a. Press Enter.
b. Type --END-- to indicate the end of the content.
c. Press Enter again.
If the content is successfully entered, the CLI displays this message
"Successfully entered Restricted Service Agreement" followed by the total
number of entered characters in parentheses.
Note: The new content of Restricted Service Agreement is saved only after
typing the apply command. See
Example
The following example illustrates how to specify the content of the Restricted
Service Agreement.
1. Type the following command and press Enter to start entering the content.
config:# security restrictedServiceAgreement bannerContent
2. Type the following content when the CLI prompts you to enter the content.
IMPORTANT!! You are accessing the PX3TS. If you are not
the system administrator, do NOT operate it or change
any settings without the permission of the system
administrator.
3. Press Enter.
4. Type the following:
--END--
5. Press Enter again.
6. Verify that the message "Successfully entered Restricted Service
Agreement" is displayed, indicating that the content input is successful.
Quitting Configuration Mode (on page 564).