LEGRAND Raritan PX3TS User Manual page 532

Chapter 7: Using the Web Interface
512
To view the status of the door and card reader:
Section Description
Shows all sensor states detected by DX2-DH2C2, including:
Door State
▪ Door: States of contact closure sensors connected to
▪ Door Lock: States of door locks integrated with the
▪ Door Handle Lock: States of the door handle locks.
Door locks and door handle locks are interrelated so their
states are changed one after another. The door handle lock
is opened first and then the door lock.
Exception: If you manually open the door lock with the key
shipped with your door handle, the Door Lock state will
enter the open state while the Door Handle Lock state
remains closed.
Shows the data of the smart card scanned by the internal
Card Reader
or external card reader accompanying each door handle
connected to DX2-DH2C2.
Note: It is not necessary to use the internal card reader
unless you are using a third-party application, such as
Power IQ, for access control. Refer to the user
documentation of your third-party application for more
information.
Tip: All sensors of the connected door handles are also listed on the page of
Peripherals (on page 258).
Note that the same Card Reader information is also available on the page of
Card Readers (on page 513).
To control the door handles:
Per default, only one door handle can be opened at the same time so you
must close one door handle before opening another door handle connected
to the same PX3TS. To increase the upper limit of concurrently opened door
handles, see Peripherals
1. Make sure you have configured the door handle type properly in the above
procedure.
DX2-DH2C2. Contact closure sensors detect whether
the door is physically opened or closed.
door handles.
(on page 258).