LEGRAND Raritan PX3TS User Manual page 336

Chapter 7: Using the Web Interface
316
Field
Client certificate,
Client private key,
Client private key
password
CA certificate
RADIUS
authentication server
name
Note: Auto-negotiation is disabled after setting both the speed and duplex
settings of the PX3TS to NON-Auto values, which may result in a duplex
mismatch.
•
Available settings for the CA Certificate:
If the required certificate file is a chain of certificates, and you are not sure
about the requirements of a certificate chain, see
page 859).
Field/setting Description
Enable verification of Select this checkbox for the PX3TS to verify the validity
TLS certificate chain of the TLS certificate that will be installed.
▪ For example, the PX3TS will check the certificate's
Description
This field appears when 'EAP', 'PEAP' and 'TLS' are
all selected.
PEM encoded X.509 certificate and PEM encoded
private key are required for certification-based
authentication methods. Private key password is
optional.
▪ PX3TS supports private keys of PKCS#1 and PKCS#8
formats.
▪ Client Private Key Password should be entered only
when your private key is encrypted with a
password.
▪ To view the uploaded certificate, click Show Client
Certificate.
▪ To remove the uploaded certificate and private
key, click 'Clear Key/Certificate selection'.
This field appears when 'EAP' is selected.
A third-party CA certificate may or may not be needed.
If needed, follow the steps below.
This field appears when 'EAP' is selected.
Type the name of the RADIUS server if it is present in
the TLS certificate.
▪ The name must match the fully qualified domain
name (FQDN) of the host shown in the certificate.
TLS Certificate Chain
validity period against the system time.
(on