External Beeper - LEGRAND Raritan PX3TS User Manual

Asset Strip Automatic Firmware Upgrade
After connecting the asset strip to the PX3TS, it automatically checks its own
firmware version against the version of the asset strip firmware stored in the
PX3TS firmware. If two versions are different, the asset strip automatically
starts downloading the new firmware from the PX3TS to upgrade its own
firmware.
During the firmware upgrade, the following events take place:
•
The asset strip is completely lit up, with the blinking LEDs cycling through
diverse colors.
•
A firmware upgrade process is indicated in the PX3TS web interface.
•
An SNMP trap is sent to indicate the firmware upgrade event.

External Beeper

After connecting and detecting a supported external beeper, the PX3TS shows
'External Beeper' in place of 'Feature Port' in the menu.
Note: For connection instructions, see
74).
To open the External Beeper page, click it in the
shows an external beeper's status, including:
•
Number of the FEATURE port where this external beeper is connected
•
Its device type
•
Its connection status
•
The beeper's state - off or active
For the functionality of this icon
(on page 279).
Chapter 7: Using the Web Interface
Connecting an External Beeper
Menu (on page 176). This page
on the top-right corner, see
(on page
Feature Port
289