LEGRAND Raritan PX3TS User Manual page 619

Determining the SSH Authentication Method
This command syntax determines the SSH authentication method.
config:# network services ssh authentication <auth_method>
Variables:
•
<option> is one of the options: passwordOnly, publicKeyOnly or
passwordOrPublicKey.
Option
passwordOnly
publicKeyOnly
passwordOrPublicKey
If the public key authentication is selected, you must enter a valid SSH public
key for each user profile to log in over the SSH connection. See
SSH Public Key (on page 643).
Setting the SNMP Configuration
You can enable or disable the SNMP v1/v2c or v3 agent, configure the read and
write community strings, or set the MIB-II parameters, such as sysContact,
using the CLI commands.
An SNMP command begins with network services snmp.
Enabling or Disabling SNMP v1/v2c
This command enables or disables the SNMP v1/v2c protocol.
config:# network services snmp v1/v2c <option>
Variables:
•
<option> is one of the options: enable or disable.
Option Description
enable The SNMP v1/v2c protocol is enabled.
disable The SNMP v1/v2c protocol is disabled.
Chapter 9: Using the Command Line Interface
Description
Enables the password-based login only.
Enables the public key-based login only.
Enables both the password- and public
key-based login. This is the default.
Specifying the
599