Retrieving Energy Usage; A Note About Enabling Thresholds - LEGRAND Raritan PX3TS User Manual

Configuring NTP Server Settings
Using SNMP, you can change the following NTP server-related settings in the
unitConfigurationTable:
•
Enable or disable synchronization of the device's date and time with NTP
servers (synchronizeWithNTPServer)
•
Enable or disable the use of DHCP-assigned NTP servers if synchronization
with NTP servers is enabled (useDHCPProvidedNTPServer)
•
Manually assign the primary NTP server if the use of DHCP-assigned NTP
servers is disabled (firstNTPServerAddressType and firstNTPServerAddress)
•
Manually assign the secondary NTP server (optional)
(secondNTPServerAddressType and secondNTPServerAddress)
Tip: To specify the time zone, use the CLI or web interface instead. For the CLI,
see Setting the Time Zone
Date and Time (on page 371).
When using the SNMP SET command to specify or change NTP servers, it is
required that both the NTP server's address type and address be set in the
command line simultaneously.
For example, the SNMP command to change the primary NTP server's address
from IPv4 (192.168.84.84) to host name looks similar to the following:
snmpset -v2c -c private 192.168.84.84
firstNTPServerAddressType = dns firstNTPServerAddress =
"angu.pep.com"

Retrieving Energy Usage

You can discover how much energy an IT device consumes by retrieving the
Active Energy for the outlet this IT device is plugged into. The Active Energy
values are included in the outletSensorMeasurementsTable, along with other
outlet sensor readings.
Note: PX3TS-1000 series does not support this functionality.

A Note about Enabling Thresholds

When enabling previously-disabled thresholds via SNMP, make sure you set a
correct value for all thresholds that are supposed to be enabled prior to
actually enabling them. Otherwise, you may get an error message.
(on page 606). For the web interface, see
Chapter 8: Using SNMP
Setting the
523