a.
Plug one end of the cable into the remaining RJ-45 port on the prior
DPX3.
b. Plug the other end into either RJ-45 port on an additional DPX3.
Repeat the same steps to cascade more DPX3 sensor packages.
3.
Connect the first DPX3 sensor package to the PX3TS by plugging its cable's
connector into the RJ-45 SENSOR port of the PX3TS.
4.
If needed, connect a DPX2 sensor package to the end of the DPX3 chain.
See
Connecting a DPX2 Sensor Package to DX2, DX or DPX3
Chapter 4: Connecting External Equipment (Optional)
(on page 50).
47