LEGRAND Raritan PX3TS User Manual page 382

Chapter 7: Using the Web Interface
Field/setting
IP address / hostname The IP address or hostname of your LDAP/LDAPS server.
Copy settings from
existing LDAP server
Type of LDAP server
Security
Port (None/StartTLS)
Port (TLS)
362
Adding LDAP/LDAPS Servers
To use LDAP authentication, enable it and enter the information you have
gathered.
Note that you must enter information in the fields showing the message
'required.'
To add LDAP/LDAPS servers:
1. Choose Device Settings > Security > Authentication.
2. Click New in the LDAP Servers section.
3. Enter information.
Description
▪ Without the encryption enabled, you can type either the domain name
or IP address in this field, but you must type the fully qualified domain
name if the encryption is enabled.
This checkbox appears only when there are existing AA server settings on
the PX3TS. To duplicate any existing AA server's settings, refer to the
duplicating procedure below.
Choose one of the following options:
▪ OpenLDAP
▪ Microsoft Active Directory. Active Directory is an implementation of
LDAP/LDAPS directory services by Microsoft for use in Windows
environments.
Determine whether you would like to use Transport Layer Security (TLS)
encryption, which allows the PX3TS to communicate securely with the
LDAPS server.
Three options are available:
▪ StartTLS
▪ TLS
▪ None
▪ The default Port is 389. Either use the standard LDAP TCP port or specify
another port.
Configurable only when "TLS" is selected in the Security field.
The default is 636. Either use the default port or specify another one.