Dpx3 Sensor Packages - LEGRAND Raritan PX3TS User Manual

Chapter 4: Connecting External Equipment (Optional)
46
Exception: You CANNOT cascade DX-PD2C5 sensor packages. One PX3TS
supports only one DX-PD2C5.
3. Connect the first DX sensor package to the PX3TS by plugging its cable's
connector into the RJ-45 SENSOR port of the PX3TS.
4. If needed, connect a DPX2 sensor package to the end of the DX chain. See
Connecting a DPX2 Sensor Package to DX2, DX or DPX3
Warning: DX-PD2C5 or DX2-DH2C2, and asset management strip(s) are
mutually exclusive so do NOT connect both of them to the PDU
simultaneously.

DPX3 Sensor Packages

A DPX3 sensor package features the following:
•
Its connection interface is RJ-45.
•
You can cascade a maximum of 12 DPX3 sensor packages.
Numbers Components
RJ-45 ports, each of which is located on
either end of a DPX3 sensor package.
LED for indicating the sensor status.
To connect DPX3 to the PX3TS:
1. Connect a standard network patch cable (CAT5e or higher) to either RJ-45
port on the DPX3 sensor package.
2. If you want to cascade DPX3 sensor packages, get an additional standard
network patch cable (CAT5e or higher) and then:
(on page 50).