Inlet Configuration Commands - LEGRAND Raritan PX3TS User Manual

▪
outletgroup modify 2 members 3-5,8,10
-- OR --
▪
outletgroup modify 2 members 3,4,5,8,10
Powering On/Off/Cycle Outlet Groups
This section applies to outlet-switching capable models only.
You must perform this operation in the administrator mode. See
Modes and Prompts (on page 527).
Power on one outlet group:
# power outletgroup <ID> on
Power off one outlet group:
# power outletgroup <ID> off
Power cycle one outlet group:
# power outletgroup <ID> cycle
To quicken the operation, you can add the parameter "/y" to the end of the
command, which confirms the operation.
For example:
# power outletgroup <ID> off /y
If you entered the command without "/y", a message appears, prompting you
to confirm the operation. Then:
▪
Type y to confirm the operation, OR
▪
Type n to abort the operation
Variables:
•
<ID> is an outlet group's index number.

Inlet Configuration Commands

An inlet configuration command begins with inlet. You can configure an inlet by
using the inlet configuration command.
Chapter 9: Using the Command Line Interface
Different CLI
633