LEGRAND Raritan PX3TS User Manual page 88

Chapter 4: Connecting External Equipment (Optional)
68
Mylar section with the adhesive tape
D
Tag ports
E
Cable socket(s) for connecting the tag
F
connector cable
Note: Each tag port on the blade extension strip is labeled a number, which is
displayed as the slot number in the PX3TS device's web interface.
To install a blade extension strip:
1. Connect the tag connector cable to the blade extension strip.
▪
Plug the cable's connector into the socket at either end of the blade
extension strip.
2. Move the blade extension strip toward the bottom of the blade chassis
until its mylar section is fully under the chassis, and verify that the blade
extension strip does not fall off easily. If necessary, you may use the
adhesive tape in the back of the mylar section to help fix the strip in place.
3. Connect one end of an asset tag to a blade server and the other end to the
blade extension strip.
a. Affix the adhesive part of the asset tag to one side of a blade server
through the tag's tape.