Alerts
The "Alerts" menu command shows a list of the following alerted sensors,
including both internal and external sensors.
•
Any numeric sensor that enters the warning or critical range if the
thresholds have been enabled
•
State sensors that enter the alarmed state
•
Any tripped circuit breakers
Tip: The same information is available in the web interface's Dashboard. See
Dashboard - Alerted Sensors
If there are no alerted sensors, the LCD display shows the message "No Alerts."
To view alerted sensors:
1.
Press
or
2.
Alerted sensors, if any, are highlighted in either red or yellow. For color
definitions, see
Yellow- or Red-Highlighted Sensors
▪
The top and bottom bars on the LCD display may be yellow or red,
depending on the type(s) of available alerts. See
Dot-Matrix LCD Display
3.
Press
or
pages, page numbers appear in the top-right corner of the display.
PDU
Depending on the model you purchased, the "PDU" menu command may show
one or all of the following data.
•
Internal beeper states -- Active or Off
•
Total active power
•
Total active energy
•
Energy pulse output settings -- available on PX3TS-5000 series only
•
12V power supply status
Tip: The internal beeper state information is also available in the PX3TS web
interface. See
PDU
(on page 206).
To view or configure PDU information:
1.
Press
or
2.
The internal beeper state is shown: Active or Off.
▪
In the Active state, the reason of turning on the beeper is indicated,
and the top/bottom bars turn red.
▪
To mute the beep sound immediately, press
Internal Beeper.
(on page 185).
to select "Alerts" in the Main Menu, and press
(on page 142).
to view additional pages. When there are multiple
to select "PDU" in the Main Menu, and press
Chapter 6: Using the PX3TS
.
(on page 264).
Operating the
.
. See Muting the
145