The Ping Tool - LEGRAND Raritan PX3TS User Manual

Messages for the USB-cascading chain:
In the Bridging mode, events regarding connection/disconnection of a
downstream slave device via USB is NOT logged.
However, in the Port Forwarding mode, whenever the connection or
disconnection of a downstream slave device via USB is detected, the PX3TS at
the USB-A end of the USB cable logs it in the internal log. Note that the PX3TS
at the USB-B end of the cable does NOT log these events.
There are two slave-related events in the Port Forwarding mode:
Event Description
Slave connected This log entry is generated when the PX3TS detects the
presence of a slave device on its USB-A port.
Slave disconnected This log entry is generated when it detects the
disconnection of a slave device from its USB-A port.

The Ping Tool

The PX3TS provides a ping tool in the web interface and CLI so you can ping any
host or PX3TS in your data center.
Ping via the Web Interface:
To log in to the web interface, see
The Ping tool is useful for checking whether a host is accessible through the
network or Internet.
•
Choose Maintenance > Network Diagnostics
Ping via the CLI:
You can access the CLI interface by connecting a computer to the PX3TS or
using SSH/Telnet. See With SSH or Telnet
1. You must perform the ping command in the diagnostic mode. See
Diagnostic Mode (on page 706).
2. Then perform the ping command. See
(on page 708).
Appendix J: Additional PX3TS Information
Login (on page 170).
(on page 526).
Testing the Network Connectivity
Entering
849