Table of Contents
Advertisement
Appendix J: Additional PX3TS Information
Installing the USB-to-Serial Driver (Optional)
850
The PX3TS can emulate a USB-to-serial converter over a USB connection. A
USB-to-serial driver named "Dominion PX2 Serial Console" is required for
Microsoft
Windows
operating systems.
®
®
Download the Windows driver for USB serial console from the Raritan
website's
Support page
(http://www.raritan.com/support/). The downloaded
driver's name is dominion-serial-setup-<n>.exe, where <n> represents the file's
version number.
There are two ways to install this driver: automatic and manual installation.
Automatic driver installation is highly recommended.
Automatic driver installation in Windows
1.
Make sure the PX3TS is NOT connected to the computer via a USB cable.
2.
Run dominion-serial-setup-<n>.exe on the computer and follow online
instructions to install the driver.
Note: If any Windows security warning appears, accept it to continue the
installation.
3.
Connect the PX3TS to the computer via a USB cable. The driver is
automatically installed.
Manual driver installation in Windows
1.
Make sure the PX3TS has been connected to the computer via a USB cable.
2.
The computer detects the new device and the "Found New Hardware
Wizard" dialog appears.
▪
If this dialog does not appear, choose Control Panel > System >
Hardware > Device Manager, right-click the Dominion PX2 Serial
Console, and choose Update Driver.
3.
Select the option of driver installation from a specific location, and then
specify the location where both dominion-serial.inf and dominion-serial.cat
are stored.
Note: If any Windows security warning appears, accept it to continue the
installation.
4.
Wait until the installation is complete.
:
®
:
®
Advertisement
Table of Contents
Troubleshooting
