Front Lcd Display - LEGRAND Raritan PX3TS User Manual

Port Used for
USB-A, Same functions as above.
USB-B,
FEATURE,
SENSOR
CONSOLE/ Same function as the one on PX3TS models. See above.
MODEM
Note that the CONSOLE/MODEM port on the iX7
(RJ-45)
connector instead of a DB9 connector. Therefore, use a third-party RJ-45 to
DB9 adapter/cable to connect iX7
Requirements for Computer Connections
ETH 10/100/1000, iX7
ETH 10/100
You can use either Ethernet port for network connection or cascading. See
Extended Cascading with PX3TS Devices
Note: The yellow LED of the ETH 10/100 port has NO function so it will not be
lit regardless of the communication status.
EXPANSION Connecting to the EXPANSION port of another iX7
to either iX7
inlet of one iX7
page 36).

Front LCD Display

has two Ethernet ports.
™
▪
ETH 10/100/1000 (marked in green) supports up to 1000 Mbps. This
is "ETH1".
▪
ETH 10/100 (marked in white) supports up to 100 Mbps. This is
"ETH2".
controller will continue whenever power failure occurs on the
™
PDU. See Power-Sharing Restrictions and Connection
™
The LCD display can show the reading or status of different components on the
PX3TS, or this device's MAC address and IP address.
It consists of:
•
An LCD display
•
Four control buttons
Depending on your PX3TS generation, the front panel display type of your
PX3TS differs. Operation ways of diverse front panel displays are also different.
•
PX3TS Character LCD Display
•
PX3TS-iX7 Dot-Matrix LCD Display
device is an RJ-45
™
to the computer. See RJ45-to-DB9 Cable
™
(on page 25).
(on page 31).
so that the power supply
™
(on page 126)
(on page 139)
Chapter 6: Using the PX3TS
(on
125