LEGRAND Raritan PX3TS User Manual page 602

Chapter 9: Using the Command Line Interface
582
Interface Description
bridge Determine the IPv6 configuration mode of the BRIDGE
interface (that is, bridging mode).
•
<mode> is one of the modes: automatic or static.
Mode Description
automatic The IPv6 configuration mode is set to automatic.
static The IPv6 configuration mode is set to static IP address.
Setting the IPv6 Preferred Host Name
After selecting DHCP as the IPv6 configuration mode, you can specify the
preferred host name, which is optional. The following is the command:
config:# network ipv6 interface <ETH> preferredHostName <name>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE.
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.
Interface Description
eth1 Determine the IPv6 preferred host name of the ETH1
interface (wired networking).
eth2 Determine the IPv6 preferred host name of the ETH2
interface (wired networking).
wireless Determine the IPv6 preferred host name of the
WIRELESS interface (that is, wireless networking).
bridge Determine the IPv6 preferred host name of the
BRIDGE interface (that is, bridging mode).
•
<name> is a host name which:
▪
Consists of alphanumeric characters and/or hyphens
▪
Cannot begin or end with a hyphen
▪
Cannot contain more than 63 characters