Table of Contents
Advertisement
Chapter 7: Using the Web Interface
354
▪
You can select any existing rule and then click
change its priority.
6.
Click Save. The rules are applied.
To configure IPv6 access control rules:
1.
On the same page, select the 'Enable role based access control for IPv6'
checkbox to enable IPv6 access control rules.
2.
Follow the same procedure as the above IPv4 rule setup to create IPv6
rules.
3.
Make sure you click the Save button in the IPv6 section, or the changes
made to IPv6 rules are not saved.
Editing or Deleting Role Based Access Control Rules
You can modify existing rules to update their roles/IP addresses, or delete them
when they are no longer needed.
To modify a role-based access control rule:
1.
Choose Device Settings > Security > Role Based Access Control.
2.
Go to the IPv4 or IPv6 section.
3.
Select the desired rule in the list.
▪
Ensure the IPv4 or IPv6 checkbox has been selected, or you may not
edit or delete any rule.
4.
Perform the desired action.
or
to
Advertisement
Table of Contents
Troubleshooting
