Table of Contents
Advertisement
Manageable Mosaic switch Installation and User Guide
Administration & SFP
Port Parameters
Serial Number
Temperature
Tx Power
Rx Power
3.3.5 Power over Ethernet (PoE)
On the main GUI main screen a PoE LED image appears above each PoE capable copper port. In
addition, in the Port View window a PoE tab appears.
The manageable Mosaic switch provides 802.3at/af (PoE+, PoE) Power Source Equipment (PSE)
capabilities with a total power capacity of up to 50 Watts on the ports. When an 802.3at/af PD device is
connected to the port, the port detects and classifies the device according to the 802.3at/af standard
and activates the PSE accordingly. If the PD device is not 802.3at/af complaint, it will not be recognized
and the port will not supply PoE power to the PD. The monitoring and management of the PoE
operation of the ports is done from the PoE tab in the Port View window.
3.3.5.1 PoE Management and Operation Tab
If a port is PoE Capable, the PoE tab of the Port View window appears (this tab is not
there in a non-PoE port). From this tab one can turn the PoE option on and off,
configure the disconnect mode, monitor general PoE characteristics and power
consumption, and reset the PoE.
Figure 3-5 Port View Window, PoE tab
Description
Monitored Transceiver internal temperature. (data available
only if the SFP transceiver supports DDM (Digital Diagnostic
Monitoring)
Monitored Transceiver Transmitted Power. (Data available
only if the SFP transceiver supports DDM (Digital Diagnostic
Monitoring)
Monitored Transceiver Received Power. (Data available only
if the SFP transceiver supports DDM (Digital Diagnostic
Monitoring)
SUMMARY
Page 22 of 87
Advertisement
Table of Contents
