•
The PX3TS device beeps after it finishes writing the diagnostic data to the
USB drive.
switch_outlets
•
This feature works on outlet-switching capable models only.
•
Switch on or off specific outlets.
•
The option's value comprises outlet numbers and the setting "on" or "off"
as explained below:
▪
Each "on" or "off" setting consists of three parts: outlet numbers, a
colon, and the word "on" or "off".
▪
Each "on" or "off" setting is separated with a semicolon.
▪
If all outlets will share the same "on" or "off" setting, replace the outlet
numbers with the word "all".
•
Examples:
▪
Turn on outlets 1 to 3, and 10, and turn off outlets 4 to 9.
switch_outlets=1,2,3:on;4-9:off;10:on
▪
Turn on all outlets.
switch_outlets=all:on
tls_cert_file
•
Specify the filename of the wanted TLS server certificate. The filename can
contain a single placeholder ${SERIAL} that is replaced with the serial
number of the PX3TS.
•
This option should be used with tls_key_file listed below.
•
This option is NOT supported by bulk configuration or backup/restore via
DHCP/TFTP.
tls_key_file
•
Specify the filename of the wanted TLS server key. The filename can
contain a single placeholder ${SERIAL} that is replaced with the serial
number of the PX3TS.
•
This option should be used with tls_cert_file listed above.
•
This option is NOT supported by bulk configuration or backup/restore via
DHCP/TFTP.
execute_lua_script
•
Specify a Lua script file. For example:
execute_lua_script=my_script.lua
Appendix C: Configuration or Firmware Upgrade with a USB Drive
737