Appendix K
Dominion KX II / III Configuration
Integration
The PX3TS can work with certain Raritan or third-party products to provide
diverse power solutions.
In This Chapter
Dominion KX II / III Configuration ..................................................................... 867
Dominion KSX II, SX or SX II Configuration ........................................................ 872
Power IQ Configuration .................................................................................... 877
dcTrack.............................................................................................................. 878
Raritan PX2, PX3 or PX3TS series can be connected to the Raritan's Dominion
KX II or KX III device (a digital KVM switch) to provide one more alternative of
power management.
Note that this integration requires the following firmware versions:
•
Dominion KX II -- 2.4 or later
•
Dominion KX III -- ALL versions
•
PX2 series -- 2.2 or later
•
PX3 series -- 2.5.10 or later
•
PX3TS series -- 2.6.1 or later
Dominion KX II or KX III integration requires D2CIM-PWR and straight CAT5
cable.
For more information on KX II / III, refer to:
•
KX II or KX III User Guide on the
(http://www.raritan.com/support/)
•
KX II or KX III Online Help on the
(http://www.raritan.com/support/online-help/)
Note: For documentation conveniences, both Dominion KX II and KX III products
are referred to as "KX III" in the following sections.
Configuring Rack PDU Targets
KX III allows you to connect rack PDUs (power strips) to KX III ports.
KX III rack PDU configuration is done from the KX III Port Configuration page.
Note: Raritan recommends no more than eight (8) rack PDUs (power strips) be
connected to a KX III at once since performance may be affected.
Support page
Product Online Help page
867