LEGRAND Raritan PX3TS User Manual page 591

config:# pdu outletSequenceDelay <outlet1>:<delay1>;<outlet2>:<delay2>;
<outlet3>:<delay3>;...
Setting the Outlet Power-On Sequence Delay
This section applies to outlet-switching capable models only.
This command sets the delays (in seconds) for outlets when turning on all
outlets in sequence.
Separate outlet numbers and their delay settings with a colon. Outlets followed
by delays are separated with a semicolon.
Variables:
•
<outlet1>, <outlet2>, <outlet3> and the like are individual outlet numbers
or a range of outlets using a dash. For example, 3-8 represents outlets 3 to
8.
•
<delay1>, <delay2>, <delay3> and the like are the delay time in seconds.
Note: Power-on sequencing is disabled in the latching mode. See
Latching Relay Behavior
Setting the PDU-Defined Default Outlet State
This section applies to outlet-switching capable models only.
This command determines the initial power condition of all outlets after
powering up the PDU.
config:# pdu outletStateOnDeviceStartup <option>
Variables:
•
<option> is one of the options: off, on or lastKnownState.
Option Description
off Switches OFF all outlets when the PX3TS powers up.
on Switches ON all outlets when the PX3TS powers up.
Chapter 9: Using the Command Line Interface
(on page 212).
PX3TS
571