LEGRAND Raritan PX3TS User Manual page 448

Chapter 7: Using the Web Interface
Placeholder
[PORTTYPE]
[RADIUSERRORDESC]
[ROMCODE]
[SENSORREADING]
[SENSORREADINGUNIT]
[SENSORREPORT]
[SENSORSTATENAME]
[SENSORTHRESHOLDNAME]
[SENSORTHRESHOLDVALUE]
[SERVERPOWEROPERATION]
[SERVERPOWERRESULT]
[SMARTCARDID]
[SMARTCARDTYPE]
[SMTPRECIPIENTS]
[SMTPSERVER]
[SYSCONTACT]
[SYSLOCATION]
[SYSNAME]
[TIMEREVENTID]
[TIMESTAMP]
[UMTARGETROLE]
[UMTARGETUSER]
[USERIP]
[USERNAME]
[VERSION]
428
Definition
The type of the external port (e.g. 'feature' or 'auxiliary')
the event-triggering device is connected to
The Radius error message
The romcode of an attached peripheral device
The value of a sensor reading
The unit of a sensor reading
The formatted sensor report contents
The human readable state of a sensor
The name of the threshold being crossed
The value of the threshold being crossed
The power control operation that was initiated on a server
(on/off)
The result of a power control operation
The id of a smart card
The type of a smart card
The list of recipients of an outgoing mail
The name or IP address of an SMTP server
SNMP MIB-II sysContact field
SNMP MIB-II sysLocation field
SNMP MIB-II sysName field
The id of a timer event
The timestamp of the event occurrence
The target role of a user management operation
The target user of a user management operation
The IP address a user connected from
The user who performed an operation
The firmware version the device is upgrading to
Note: In case you need to type any square brackets "[" and "]" in the custom
message for non-placeholder words, always add a backslash in front of the
square bracket. That is, \[ or \]. Otherwise, the message sent will not display the
square brackets.