Configuring Network Settings - LEGRAND Raritan PX3TS User Manual

Chapter 7: Using the Web Interface
310

Configuring Network Settings

Configure wired, wireless, and Internet protocol-related settings on the
Network page after Connecting the PX3TS to Your Network
You can enable both the wired and wireless networking on PX3TS so that it has
multiple IP addresses -- wired and wireless IP. For example, you can obtain one
IPv4 and/or IPv6 address by enabling one Ethernet interface, and obtain one
more IPv4 and/or IPv6 address by enabling/configuring the wireless interface.
This also applies when PX3TS enters the port forwarding mode so that PX3TS
has more than one IPv4 or IPv6 address in the port forwarding mode.
However, PX3TS in the BRIDGING mode obtains "only one" IP address for wired
networking. Wireless networking is NOT supported in this mode.
Important: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces
do NOT function.
To set up the network settings:
1. Choose Device Settings > Network.
2. To use DHCP-assigned DNS servers and gateway instead of static ones, go
to step 3. To manually specify DNS servers and default gateway, configure
the Common Network Settings section. See
page 313).
▪
Static routes and cascading mode are also in this section. You need to
configure them only when there are such local requirements. See
Setting the Cascading Mode
(on page 324).
3. To configure IPv4/IPv6 settings for a wired network, click the ETH1/ETH2 or
BRIDGE section. See
▪
If the device's cascading mode is set to 'Bridging', the BRIDGE section
appears. Then you must click the BRIDGE section for IPv4/IPv6
settings.
4. To configure IPv4/IPv6 settings for a wireless network, click the WIRELESS
section. See Wireless Network Settings
▪
You must connect a USB wireless LAN adapter to the PX3TS for
wireless networking.
Note: If the device's cascading mode is set to 'Bridging' or its role is set to
'Slave' in the port forwarding mode, the wireless settings will be disabled.
5. To configure the ETH1/ETH2 interface settings, see
Settings (on page 314).
6. Click Save.
Common Network Settings
(on page 328) and
Wired Network Settings
(on page 317).
(on page 13).
Static Route Examples
(on page 311).
Ethernet Interface
(on