Table of Contents
Advertisement
Specifying the SSH Public Key
If the SSH key-based authentication is enabled, specify the SSH public key for
each user profile using the following procedure.
To specify or change the SSH public key for a specific user:
1.
Type the SSH public key command as shown below and press Enter.
config:#
user modify <name> sshPublicKey
2.
The system prompts you to enter the contents of the SSH public key. Do
the following to input the contents:
a.
Open your SSH public key with a text editor.
b. Copy all contents in the text editor.
c.
Paste the contents into the terminal.
d. Press Enter.
To remove an existing SSH public key:
1.
Type the same command as shown above.
2.
When the system prompts you to input the contents, press Enter without
typing or pasting anything.
Example
The following procedure illustrates how to change the SSH public key for the
user "assistant."
1.
Verify that you have entered the configuration mode. See
Configuration Mode
2.
Type the following command and press Enter.
config:#
user modify assistant sshPublicKey
3.
You are prompted to enter a new SSH public key.
4.
Type the new key and press Enter.
Deleting a User Profile
This command deletes an existing user profile.
config:#
user delete <name>
Chapter 9: Using the Command Line Interface
(on page 563).
Entering
643
Advertisement
Table of Contents
Troubleshooting
