LEGRAND Raritan PX3TS User Manual page 680

Chapter 9: Using the Command Line Interface
config:# authentication radius add <host> <rds_type> <auth_port> <acct_port> <timeout>
<retries>
660
Removing an Existing LDAP Server
This command removes an existing LDAP server from the server list.
config:# authentication ldap delete <server_num>
Variables:
•
<server_num> is the sequential number of the specified server in the LDAP
server list.
Radius Settings
All Radius-related commands begin with authentication radius.
If you enable Radius authentication, you must add at least one Radius server.
Later you can modify or delete any existing Radius server as needed.
Adding a Radius Server
You can repeat the following commands to add Radius servers one by one.
Command syntax:
Variables:
•
<host> is the IP address or host name of the Radius server.
•
<rds_type> is one of the Radius authentication types: pap, chap,
msChapV2.
Type Description
chap
CHAP
pap
PAP
msChapV2
MSCHAP v2
•
<auth_port> is the authentication port number.
•
<acct_port> is the accounting port number.
•
<timeout> is the timeout value in seconds. It ranges between 1 to 10
seconds.
•
<retries> is the number of retries. It ranges between 0 to 5.
To enter the shared secret:
1. After executing the above Radius command, the system automatically
prompts you to enter the shared secret.
2. Type the secret and press Enter.
3. Re-type the same secret and press Enter.