Checking The Accessibility Of Ntp Servers; Security Configuration Commands - LEGRAND Raritan PX3TS User Manual

Chapter 9: Using the Command Line Interface
config:# security ipAccessControl ipv4 enabled <option>
608

Checking the Accessibility of NTP Servers

This command verifies the accessibility of NTP servers specified manually on
your PX3TS and then shows the result. For instructions on specifying NTP
servers via CLI, see Setting NTP Parameters
To perform this command successfully, you must:
•
Own the "Change Date/Time Settings" permission.
•
Customize NTP servers. See
This command is available either in the administrator/user mode or in the
configuration mode. See
In the administrator/user mode:
# check ntp
In the configuration mode:
config# check ntp

Security Configuration Commands

A security configuration command begins with security.
Firewall Control
You can manage firewall control features through the CLI. The firewall control
lets you set up rules that permit or disallow access to the PX3TS from a specific
or a range of IP addresses.
•
An IPv4 firewall configuration command begins with security
ipAccessControl ipv4.
•
An IPv6 firewall configuration command begins with security
ipAccessControl ipv6.
Modifying Firewall Control Parameters
There are different commands for modifying firewall control parameters.
•
IPv4 commands
Enable or disable the IPv4 firewall control feature:
Determine the default IPv4 firewall control policy for inbound traffic:
(on page 605).
Setting NTP Parameters
Different CLI Modes and Prompts
(on page 605).
(on page 527).