Overcurrent Protector Configuration Commands - LEGRAND Raritan PX3TS User Manual

Chapter 9: Using the Command Line Interface
634
Changing the Inlet Name
This command syntax names an inlet.
config:# inlet <n> name "<name>"
Variables:
•
<n> is the number of the inlet that you want to configure. For a single-inlet
PDU, <n> is always 1. The value is an integer between 1 and 50.
•
<name> is a string comprising up to 64 ASCII printable characters. The
<name> variable must be enclosed in quotes when it contains spaces.
Example - Inlet Naming
The following command assigns the name "AC source" to the inlet 1. If your
PX3TS contains multiple inlets, this command names the 1st inlet.
config:# inlet 1 name "AC source"

Overcurrent Protector Configuration Commands

An overcurrent protector configuration command begins with ocp. The
command configures an individual circuit breaker or fuse which protects
outlets.
Changing the Overcurrent Protector Name
This command names a circuit breaker or a fuse which protects outlets on your
PX3TS.
config:# ocp <n> name "<name>"
Variables:
•
<n> is the number of the overcurrent protector that you want to configure.
The value is an integer between 1 and 50.
•
<name> is a string comprising up to 64 ASCII printable characters. The
<name> variable must be enclosed in quotes when it contains spaces.