Table of Contents
Advertisement
Chapter 7: Using the Web Interface
344
▪
Public key authentication only: Enables the public key-based login only.
▪
Password and public key authentication: Enables both the password-
and public key-based login. This is the default.
5.
Click Save.
If the public key authentication is selected, you must enter a valid SSH public
key for each user profile to log in over the SSH connection. See
(on page 297).
Changing Telnet Settings
You can enable or disable the Telnet access to the command line interface, or
change the TCP port.
To change Telnet settings:
1.
Choose Device Settings > Network Services > Telnet.
2.
To enable the Telnet access, select the checkbox.
3.
To use a different port, type a new port number.
4.
Click Save.
Changing Modbus Settings
The PX3TS supports both the Modbus/TCP and Modbus Gateway features.
Enable either or both Modbus features according to your needs.
Modbus/TCP Access:
You can enable or disable the Modbus/TCP access to PX3TS, set it to the
read-only mode, or change the TCP port.
1.
Choose Device Settings > Network Services > Modbus.
2.
To enable the Modbus/TCP access, select the "Enable Modbus/TCP access"
checkbox.
3.
To use a different port, type a new port number.
4.
To enable the Modbus read-only mode, select the checkbox of the "Enable
read-only mode" field. To enable the read-write mode, deselect it.
Creating Users
Advertisement
Table of Contents
Troubleshooting
