Power Cim - LEGRAND Raritan PX3TS User Manual

SHX Request Maximum Cooling
The PX3TS allows you to remotely activate the Schroff SHX 30's maximum
cooling feature. Both LHX 20 and LHX 40 do not support remote activation of
maximum cooling.
The Request Maximum Cooling feature is available only after the PX3TS detects
SHX 30. For additional information on the SHX 30 maximum cooling feature,
refer to the SHX 30 documentation.
To perform maximum cooling:
•
Go to the SHX page, and click Request Maximum Cooling.
Then the SHX 30 enters into emergency cooling mode and runs at its
maximum cooling level of 100% in order to cool the device.
When maximum cooling is requested for an SHX 30, the message
"Maximum cooling requested" is displayed.
To stop maximum cooling:
•
Click Cancel Maximum Cooling.

Power CIM

After connecting and detecting a Raritan power CIM, the PX3TS shows 'Power
CIM' in place of 'Feature Port' in the menu. See
Configuration (on page 867) or
page 872).
Open the Power CIM page by clicking it in the
shows the CIM's status, including:
•
Number of the FEATURE port where this CIM is connected
•
Its device type
•
Its connection status
For the functionality of this icon
(on page 279).
Chapter 7: Using the Web Interface
Dominion KX II / III
Dominion KSX II, SX or SX II Configuration
Menu (on page 176). This page
on the top-right corner, see
(on
Feature Port
295