Yellow- Or Red-Highlighted Sensors - LEGRAND Raritan PX3TS User Manual

Chapter 7: Using the Web Interface
Sensor status Color
Unknown
264
: Turn ON.
: Turn OFF.
Note: Per default you can turn on as many dry contact actuators as you
want, but only one "powered dry contact" actuator can be turned on at the
same time. To change this limitation of "powered dry contact" actuators,
modify the active powered dry contact setting. See
258).
4. Confirm the operation when prompted.
If you select a DX2-DH2C2 door handle lock, then the Open and Close buttons
appear. For detailed operations, see
511).
Tip: If intending to control the actuator via the front panel, see
Settings (on page 454).

Yellow- or Red-Highlighted Sensors

The PX3TS highlights those sensors that enter the abnormal state with a yellow
or red color. Note that numeric sensors can change colors only after you have
enabled their thresholds.
Tip: When an actuator is turned ON, it is also highlighted in red for drawing
attention.
For concepts of thresholds, deassertion hysteresis and assertion timeout, see
Sensor Threshold Settings
In the following table, "R" represents any numeric sensor's reading. The symbol
<= means "smaller than" or "equal to."
States shown in
the interface
unavailable
Door Handle Status and Control
(on page 834).
Description
Sensor state or readings cannot be detected.
Peripherals (on page
(on page
Front Panel