Chapter 9: Using the Command Line Interface
The ? Command for Showing Available Commands
528
Closing a Local Connection
Close the window or terminal emulation program when you finish accessing
the PX3TS over the local connection.
When accessing or upgrading multiple PX3TS devices, do not transfer the
local connection cable from one device to another without closing the local
connection window first.
When you are not familiar with CLI commands, you can press the ? key at
anytime for one of the following purposes.
•
Show a list of main CLI commands available in the current mode.
•
Show a list of available commands or parameters for the command you
type. See
Querying Available Parameters for a Command
In the administrator mode:
#
?
In the configuration mode:
config:#
?
In the diagnostic mode:
diag:#
?
Press Enter after pressing the ? command, and a list of main commands for the
current mode is displayed.
Tip: To automatically complete a command after typing part of the full
command, see
Automatically Completing a Command
re-execute one of the previous commands, see
(on page 709).
(on page 529).
(on page 709). To
Retrieving Previous Commands