Usb Wireless Lan Adapters; Supported Wireless Lan Configuration - LEGRAND Raritan PX3TS User Manual

▪
Connect a USB hub to the USB-A port on the PX3TS. Then plug the
supported USB wireless LAN adapter into the appropriate USB port on
the hub.
See

USB Wireless LAN Adapters

wireless LAN adapters.
USB Wireless LAN Adapters
The PX3TS supports the following USB Wi-Fi LAN adapters.
Wi-Fi LAN adapters
SparkLAN WUBR-508N
Proxim Orinoco 8494
Zyxel NWD271N
Edimax EW-7722UnD
TP-Link TL-WDN3200 v1
Raritan USB WIFI

Supported Wireless LAN Configuration

If wireless networking is preferred, ensure that the wireless LAN configuration
of your PX3TS matches the access point. The following is the wireless LAN
configuration that the PX3TS supports.
▪
Network type: 802.11 A/B/G/N
▪
Protocol: WPA2 (RSN)
▪
Key management: WPA-PSK, or WPA-EAP with PEAP and MSCHAPv2
authentication
▪
Encryption: CCMP (AES)
Tip: Supported 802.11 network protocols vary according to the wireless LAN
adapter being used with the PX3TS. See USB Wireless LAN Adapters (on page
15).
Note: You must configure PX3TS to enable its wireless LAN interface. See the
topic titled Configuring Network Settings (on page 310) in the User Guide.
Chapter 3: Initial Installation and Configuration
(on page 15) for a list of supported
Supported 802.11
protocols
A/B/G/N
A/B/G
B/G
A/B/G/N
A/B/G/N
A/B/G/N
15