LEGRAND Raritan PX3TS User Manual page 694

Chapter 9: Using the Command Line Interface
config:# sensor ocp <n> <sensor type> upperCritical <option>
config:# sensor ocp <n> <sensor type> upperWarning <option>
config:# sensor ocp <n> <sensor type> lowerCritical <option>
config:# sensor ocp <n> <sensor type> lowerWarning <option>
config:# sensor ocp <n> <sensor type> hysteresis <hy_value>
config:# sensor ocp <n> <sensor type> assertionTimeout <as_value>
674
Commands for Overcurrent Protector Sensors
A sensor configuration command for overcurrent protectors begins with sensor
ocp.
You can configure various overcurrent protector threshold settings at a time by
combining multiple commands. See
Set the Upper Critical threshold for an overcurrent protector:
Set the Upper Warning threshold for an overcurrent protector:
Set the Lower Critical threshold for an overcurrent protector:
Set the Lower Warning threshold for an overcurrent protector:
Set the deassertion hysteresis for an overcurrent protector:
Set the assertion timeout for an overcurrent protector:
Variables:
•
<n> is the number of the overcurrent protector that you want to configure.
•
<sensor type> is one of the following sensor types:
Sensor type
current
Note: If the requested sensor type is not supported, the "Sensor is not
available" message is displayed.
Multi-Command Syntax
Description
Current sensor
(on page 695).