LEGRAND Raritan PX3TS User Manual page 664

Chapter 9: Using the Command Line Interface
644
Changing Your Own Password
Every user can change their own password via this command if they have the
Change Own Password privilege. Note that this command does not begin with
user.
config:# password
After performing this command, the PX3TS prompts you to enter both current
and new passwords respectively.
Important: After the password is changed successfully, the new password is
effective immediately no matter you type the command "apply" or not to
save the changes.
Example
This procedure changes your own password:
1. Verify that you have entered the configuration mode. See
Configuration Mode
2. Type the following command and press Enter.
config:# password
3. Type the existing password and press Enter when the following prompt
appears.
Current password:
4. Type the new password and press Enter when the following prompt
appears.
Enter new password:
5. Re-type the new password for confirmation and press Enter when the
following prompt appears.
Re-type new password:
Setting Default Measurement Units
Default measurement units, including temperature, length, and pressure units,
apply to the PX3TS user interfaces across all users except for those whose
preferred measurement units are set differently by themselves or the
administrator. Diverse measurement unit commands can be combined so that
you can set all default measurement units at a time. To combine all commands,
see Multi-Command Syntax
Note: The measurement unit change only applies to the web interface and
command line interface.
(on page 563).
(on page 695).
Entering