Managing One Sensor Or Actuator - LEGRAND Raritan PX3TS User Manual

Managing One Sensor or Actuator

If you are managing only one sensor or actuator, you can assign the desired ID
number to it. Note that you cannot assign ID numbers when managing multiple
sensors/actuators at a time.
Tip: When the total of managed sensors/actuators reaches the maximum value,
you cannot manage additional ones. The only way to manage any
sensor/actuator is to release or replace the managed ones. To replace a
managed one, assign an ID number to it by following the procedure below. To
release any one, see Peripherals
To manage only one sensor/actuator:
1. From the list of "unmanaged" sensors/actuators, click the one you want to
manage.
2. The Manage Peripheral Device dialog appears.
▪
To let PX3TS randomly assign an ID number to it, select "Automatically
assign a sensor number."
This method does not release any managed sensor or actuator.
▪
To assign a desired ID number, select "Manually select a sensor
number." Then click
This method may release a managed sensor/actuator if the number
you selected has been assigned to a specific sensor/actuator.
Tip: The information in parentheses following each ID number indicates
whether the number has been assigned to a sensor or actuator. If it has
been assigned to a sensor or actuator, it shows the sensor package's serial
number. Otherwise, it shows the word "unused."
3. Click Manage.
Chapter 7: Using the Web Interface
(on page 258).
to select an ID number.
271