Table of Contents
Advertisement
Chapter 9: Using the Command Line Interface
532
Network Configuration
This command shows all network configuration and all network interfaces'
information, such as the IP address, MAC address, the Ethernet interfaces'
duplex mode, and the wireless interface's status/settings.
#
show network
IP Configuration
This command shows the IP settings shared by all network interfaces, such as
DNS and routes. Information shown will include both IPv4 and IPv6
configuration.
Tip: To show IPv4-only and IPv6-only configuration data, see
IPv6-Only Configuration
#
show network ip common
To show the IP settings of a specific network interface, use the following
command.
#
show network ip interface <ETH>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE.
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.
Interface
Description
eth1
Show the IP-related configuration of the ETH1
interface.
Show the IP-related configuration of the ETH2
eth2
interface.
wireless
Show the IP-related configuration of the WIRELESS
interface.
bridge
Show the IP-related configuration of the BRIDGE
interface.
(on page 533).
IPv4-Only or
Advertisement
Table of Contents
Troubleshooting
