LEGRAND Raritan PX3TS User Manual page 586

Chapter 9: Using the Command Line Interface
566
Configuring Power Transfer Features
Enter the configuration mode to change the following power transfer settings.
See Entering Configuration Mode
You can change various power transfer settings at a time by combining various
commands. See Multi-Command Syntax
Enable or disable the front panel Manual Transfer button:
config:# ts manualTransferButton <option1>
Enable or disable automatic retransfer:
config:# ts autoRetransfer <option2>
Determine the wait time for automatic retransfer after the preferred
inlet restores to normal:
config:# ts autoRetransferWaitTime <option3>
Enable or disable the phase sync requirement for automatic retransfer:
config:# ts noAutoRetransferOnPhaseDifferenceFault <option4>
Name the transfer switch:
config:# ts name "<name>"
Variables:
•
<option1> is one of the options: enable or disable.
Option Description
enable The Manual Transfer button is enabled.
disable The Manual Transfer button is disabled.
•
<option2> is one of the options: enable or disable.
Option Description
enable Enables the automatic retransfer.
disable Disables the automatic retransfer.
(on page 563).
(on page 695).