LEGRAND Raritan PX3TS User Manual page 608

Chapter 9: Using the Command Line Interface
588
Changing the LAN Duplex Mode
This command determines the LAN interface duplex mode.
config:#
network ethernet <ETH> duplexMode <mode>
Variables:
•
<ETH> is one of the options -- eth1 or eth2.
Option Description
eth1 ETH1 port
eth2 ETH2 port
•
<mode> is one of the modes: auto, half or full.
Option Description
auto The PX3TS selects the optimum transmission mode
through auto-negotiation.
half Half duplex:
Data is transmitted in one direction (to or from the
PX3TS) at a time.
full Full duplex:
Data is transmitted in both directions simultaneously.
Setting Wireless Parameters
You must configure wireless parameters, including Service Set Identifier (SSID),
authentication method, Pre-Shared Key (PSK), and Basic Service Set Identifier
(BSSID) after the wireless networking mode is enabled.
A wireless configuration command begins with network wireless.
Note: If wireless networking mode is not enabled, the SSID, PSK and BSSID
values are not applied until the wireless networking mode is enabled. In
addition, a message appears, indicating that the active network interface is not
wireless.