Table of Contents
Advertisement
a.
Turn the holder counterclockwise to loosen it.
b. Remove the holder.
6.
Separate the fuse from the holder.
7.
Insert a new fuse into the holder. Make sure the new fuse is identical to
the original one.
8.
Install back the fuse holder to the PX3TS and turn it clockwise until it is
tightened properly.
9.
Reconnect the inlet with the fuse replaced to power, if it was disconnected
in Step 4.
10. (Optional) You can perform manual transfer back to that inlet, if preferred.
See
Manual Transfer
(on page 112).
Chapter 6: Using the PX3TS
165
Advertisement
Table of Contents
Troubleshooting
